Install The Raid Super Capacitor Module On; The Air Baffle - Lenovo ThinkSystem SR630 Maintenance Manual

Procedure
Step 1. Remove the top cover. See "Remove the top cover" on page 220.
Step 2. Disconnect the cable of the RAID super capacitor module.
Step 3. Remove the air baffle from the chassis. See "Remove the air baffle" on page 91.
Step 4. Remove the RAID super capacitor module on the air baffle.
Figure 120. Removal of the RAID super capacitor module on the air baffle
a. Open the retention clip on the holder of the RAID super capacitor module.
b. Take the RAID super capacitor module out of the holder.
After you finish
If you are instructed to return the old RAID super capacitor module, follow all packaging instructions and use
any packaging materials that are provided.
Install the RAID super capacitor module on the air baffle
Use this information to install the RAID super capacitor module on the air baffle.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
.
Chapter 4 Hardware replacement procedures
195