Lenovo ThinkSystem SR630 Maintenance Manual page 159

– Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid
metals may damage the memory modules.
– Do not insert memory modules while holding packages or passive components, which can cause
package cracks or detachment of passive components by the high insertion force.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Remove the top cover. See "Remove the top cover" on page 220.
Step 2. If your server comes with an air baffle, remove it. See "Remove the air baffle" on page 91.
Step 3. Remove the memory module from the slot.
mm
Figure 86. Memory module removal
a. Open the retaining clip on each end of the memory module slot.
Attention: To avoid breaking the retaining clips or damaging the memory module slots, handle
the clips gently.
b. Grasp the memory module at both ends and carefully lift it out of the slot.
After you finish
1. Install a memory module filler or a new memory module to cover the slot. See "Install a memory module"
on page 164.
2. If you are instructed to return the old memory module, follow all packaging instructions and use any
packaging materials that are provided.
.
Chapter 4 Hardware replacement procedures
149