• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack. See
Step 2.
Remove the top cover. See
Step 3.
Remove the M.2 drive.
Figure 41. Removing the M.2 drive
a.
Press both sides of the retainer
b.
Slide the retainer away from the M.2 drive.
c.
Rotate the rear end of M.2 drive to an angle of approximately 30 degrees.
d.
Pull the M.2 drive away from the connector
After you finish
1. Install a new M.2 drive. See
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an M.2 drive
Follow instructions in this section to install an M.2 drive.
Attention:
• Read
"Installation Guidelines" on page 39
work safely.
ThinkSystem SR665 V3 User Guide
84
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
.
2
"Install an M.2 drive" on page
and
"Safety inspection checklist" on page 40
"Remove the server from rack" on page
161.
.
1
84.
49.
to ensure that you