4. Complete the parts replacement. See
Front I/O module replacement
Follow instructions in this section to remove and install the front I/O module.
The front I/O module varies by model. The front I/O module for most models is on the right rack latch. The
front I/O module on media bay is supported only in the following server models:
• Server models with eight 2.5-inch front drive bays
• Server models with sixteen 2.5-inch front drive bays
Front I/O module (on rack latch)
To replace the front I/O module on the rack latch, see
To replace the front I/O module on the media bay:
•
"Remove the front I/O module" on page 73
•
"Install the front I/O module" on page 75
Remove the front I/O module
Follow instructions in this section to remove the front I/O module.
About this task
Attention:
• Read
"Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
"Complete the parts replacement" on page
Front I/O module (on media bay)
"Rack latches replacement" on page
and
"Safety inspection checklist" on page 40
48.
164.
.
Chapter 5
Hardware replacement procedures
122.
to ensure that you
73