Figure 32. Installing the 8-bay drive backplane
a.
Align the bottom of the backplane with the slots on the chassis, and lower the backplane
into the chassis.
b.
Rotate the backplane to the vertical position. Align the holes in the backplane with the pins
on the chassis, and press the backplane into position. The release tabs will secure the
backplane in place.
Step 3.
Connect the cables to the drive backplane. See
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
2. Reinstall the fan cage. See
3. Reinstall the air baffle if you have removed it. See
4. Complete the parts replacement. See
"Install the system fan cage" on page
"Install the air baffle" on page
"Complete the parts replacement" on page
Chapter 6 "Internal cable routing" on page
"Install a hot-swap drive" on page
160.
.
Chapter 5
Hardware replacement procedures
167.
78.
59.
164.
69