Lenovo ThinkSystem SR665 V3 User Manual page 72

S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. Remove any parts and disconnect any cables that might impede your access to the CMOS
battery.
Step 2. Locate the CMOS battery. See
Step 3. Remove the CMOS battery.
Attention:
• Differentiate between the positive and negative ends of the battery socket as shown below.
• Failing to remove the CMOS battery properly might damage the socket on the processor board.
Any damage to the socket might require replacing the processor board.
• Do not tilt or push the CMOS battery by using excessive force.
ThinkSystem SR665 V3 User Guide
62
and "Safety inspection checklist" on page 40
48.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
"System-board-assembly connectors" on page
"Remove the server from rack" on page
161.
to ensure that you
49.
21.