Binary Outputs; Outputs For Controlling And Signaling - Hitachi Relion 650 Series Technical Manual

Section 15
IED physical connections
15.3

Binary outputs

The precision binary outputs are used for time-synchronized energization of the circuit breaker Close
and Trip coils. These outputs are normally open.
Each connector terminal is connected with one one 0.5...2.5 mm² (AWG 20...13) wire or with two
0.5...1.0 mm² (AWG 20...17) wires.
Table 405: Open and close command outputs
Connector
X321
X321
X321
X321
X321
X321
X321
X321
X321
X321
X321
X321
15.3.1

Outputs for controlling and signaling

Signal output contacts are used for signalling alarms and warning conditions. See
on each output signal.
Outputs designated "PO" are power output contacts designed for controlling switchgear. Three of the
power outputs on the power supply module (PSM) feature additional circuitry for trip circuit
supervision.
Connectors are delivered with the device. Each connector terminal is connected with one 0.5...2.5
mm² (AWG 20...13) wire or with two 0.5...1.0 mm² (AWG 20...17) wires.
Table 406: Power outputs on PSM (not used in PWC600 pre-configuration)
Connector
X317
X317
Table continues on next page
422
Pin Signal
1 L1 Close -
2 L1 Close +
3 L2 Close -
4 L2 Close +
5 L3 Close -
6 L3 Close +
7 L1 Open -
8 L1 Open +
9 L2 Open -
10 L2 Open +
11 L3 Open -
12 L3 Open +
The connected DC voltage to outputs with trip circuit supervision (TCS) must have
correct polarity or the trip circuit supervision TCSSCBR function will not operate
properly.
Pin
1
2
3
4
© 2021 Hitachi Energy. All rights reserved.
Description
Controlled close command output L1
Controlled close command output L2
Controlled close command output L3
Controlled open command output L1
Controlled open command output L2
Controlled open command output L3
Description PCM600 Info
Hardware module
Power output 1,
normally open (TCS)
– PSM_102
+
Power output 2,
normally open (TCS)
– PSM_102
+
1MRK 511 557-UEN Rev. A
D0E8360T201305151403 v5
Software signal
PIO_3.PBO1
PIO_3.PBO2
PIO_3.PBO3
PIO_3.PBO4
PIO_3.PBO5
PIO_3.PBO6
D0E8361T201305151403 v5
Section for details
Hardware channel
BO1_PO_TCS
BO2_PO_TCS
Technical Manual