Table of Contents
Advertisement
The following is a description of each alarm and the
recommended procedure(s) to resolve the problem.
System Is In Permanent Rain Hold
When the TouchNet is put into Permanent Rain Hold, an alarm
is generated to remind you that no irrigation will take place
while the system is in this mode.
Update Time Is In The Watering Cycle
If you select an Update Time which would occur during an
irrigation cycle, this alarm will be generated. The Update Time
should be set to occur at least 1 hour before the start of any
irrigation cycle. If the Update Time occurs during a water
cycle, the TouchNet flow manager system will be unable to
perform system update calculations properly.
To resolve the alarm, reset the Update Time to occur at least
1 hour before the earliest start time.
Watering Cycle Ends Past Limit
An alarm will be generated if a programmed watering cycle
duration extends past the Water Window End Time limit.
To resolve the alarm, use one or more of the following options:
• Adjust the total run time or change to an earlier start time.
• On the Water Window screen, extend the End Time Limit
(which may also require extending the Day Change Time).
• Select WATER ANYWAY.
Watering Cycle Ends Past Day Change
An alarm will be generated if the calculated watering cycle will
end beyond the watering Day Change time.
If this situation occurs, the watering cycle will be ignored and
no watering will take place for the entire watering day.
To resolve the alarm, use one or more of the following options:
• Adjust down the station run time.
• Change to an earlier start time.
• Change to a later watering Day Change time.
Too Many Events To Schedule
If more stations have been scheduled to operate within a
watering day than can be properly managed by the TouchNet,
this alarm will be generated.
To resolve the alarm, reschedule your irrigation cycle to run
fewer stations per watering day.
41
Special Features – 6
RELEASED Version
©Toro 2006-2006
Advertisement
Table of Contents
