Table of Contents
Advertisement
Programming The Controller – 4
Figure 27 - The Starts screen after sorting the programs by priority.
To reprogram the sequence start, you can reset all programs to
"0" priority by pressing the CLEAR function key.
Set Syringe Time
Within the Starts screen, you can set a program to run a syringe
cycle instead of its normal station run times. To do this, select
the desired program in the Syringe column and use the pop-up
keypad to set the amount of syringe time (1–30 minutes).
During operation, the syringe run time will override the normal
station run time.
Repeat these programming steps for each watering sequence
start required (12 starts maximum).
Total Run Time Calculation
The TOTAL box indicates the calculated run time for the entire
watering sequence. This information will appear after the
TouchNet performs the flow management calculations at the
Update Time (specified on the Setup screen) and/or after
CALCULATED END TIME is selected on the Water Window
screen. In our example, the total run time required for
sequence start number 1 is 9 hours.
To enable the TouchNet to operate manually or automatically,
the flow management calculations must first be performed.
To accomplish this, refer to Calculated End Time on page 38.
This completes the TouchNet programming procedure. If you
wish to test the system operation, continue to "Manual
Operation" on page 31.
29
RELEASED Version
©Toro 2006-2006
Advertisement
Table of Contents
