Set Program Run Time And Flow - Toro TouchNet NO-90-06 User Manual

Programming The Controller – 4

Set Program Run Time and Flow

In addition to assigning a program name, you can define the
default station run times and station flow rates for each
program. This data will be carried forward to the Satellite
Stations screen to expedite the programming process. Enter the
run time and flow rate which will be used for the majority of
stations to be assigned to each program.
Figure 18 - The Programs screen.
Enter this information into the appropriate box for each
program using the pop-up keypad.
The run time is entered in minutes (0–255), but is displayed in
hours and minutes (0:00–4:15).
The station flow rate must not exceed the System and/or
Zone flow limits. A system alarm will be generated if this
occurs.
To scroll forward through the program list, touch the
>> <<
key. To scroll backward, touch the key.
PGM PGM
The data entered on the Programs screen is for default value
setup purposes only. After the initial satellite programming
steps are accomplished, further changes in the Program screen
will not automatically update the data on the Satellite Stations
screen.
21
RELEASED Version ©Toro 2006-2006