Table of Contents
Advertisement
Special Features – 6
The actual water window will begin at the earliest scheduled
sequence start time (shown as the Water Window Start time)
and end at the Calculated End Time or at a specified End Time
Limit.
Figure 34 - The Water Window screen.
The selections provided on the Water Window screen will not
directly alter the watering schedule to make it fit within the
water window. It will however, enable you to allow the system
to run past the limit, or stop all watering at the limit if you
choose. If run time adjustments are required, the Adjust screen
can be easily accessed by touching the ADJUST box.
End Time Limit
The End Time Limit is the time you decide that the watering
cycle must be completed. To set the End Time Limit, touch the
time display box adjacent to END TIME LIMIT and enter the
desired time using the pop-up keypad.
To prevent a system alarm, the End Time Limit must be set to
occur at least 1 minute before the Day Change time.
Calculated End Time
The Calculated End Time is derived from the total run time of
all stations programmed to water on the same day. Touching
the time display box adjacent to CALCULATED END TIME
prompts the HydroGuard flow manager to calculate the
watering schedule for the day and display the watering end
time. The total watering time for the watering day is displayed
on the Starts screen TOTAL box as shown on page 28. This
calculation automatically occurs at the scheduled Update Time.
38
RELEASED Version
©Toro 2006-2006
Advertisement
Table of Contents
