Control Elements And Application Parameter; Switch" Control Element; Name Of The Control Element; Function Of The Control Element - ABB IP Touch 7 Manual

2

Control elements and application parameter

2.1

"Switch" control element

2.1.1

Name of the control element

Options:
Naming the switch control element, e.g. name of the lamp that is to be switched.
The length of the name is limited to 36 characters.
2.1.2

Function of the control element

Options:
The parameter is used to specify the colour of the function line.
"Light (yellow)" has been made available for functions of this type.
2.1.3

Size of the button

Options:
The parameter is used to specify whether the control element occupies one column (one button
or control frame) or two columns (two buttons or control frames).
2.1.4

Type of switch

Options:
Notice
The selection depends on the type of switch.
The parameter is used to specify the signals (values) the switch sends to the KNX bus when it
is operated.
– Switchover: No additional parameters available.
– Pressing/releasing: Pressing = value 1; releasing = value 2.
The following supplementary parameters are available, see chapter 2.1.5 "Object type 1 /
value 2" on page 48:
Product manual 2CKA001473B5023
Control elements and application parameter
<Name>
Not defined (grey)
Light (yellow)
Blind (blue)
Temperature (orange)
Scene (magenta)
Alarm (red)
Feedback (green)
1 column
2 columns
Switchover
Press/release
Short/long
"Switch" control element
│46