Setpoint Settings - Set-Point Temperature For Frost Protection (°C); Setpoint Settings - Send Current Setpoint; Setpoint Settings - Cyclic Sending Of The Current Set-Point Temperature (Min); Setpoint Adjustment - Maximum Manual Increase During Heating Mode (0 - 9°C) - ABB IP Touch 7 Manual

2.21.26 Setpoint settings — Set-point temperature for frost protection (°C)
Options:
Function for protecting the building against the cold. On devices with a display, this mode is
indicated by the frost protection icon. Manual operation is blocked.
Note
This parameter is only available when the "Control function" parameter is set on
"Heating", "Heating with additional stage", "Heating and cooling" or "Heating and
cooling with additional stages".
2.21.27 Setpoint settings — Send current setpoint
Options:
The current setpoint value can be sent to the bus either cyclically and after a change, or only
after a change.
2.21.28 Setpoint settings — Cyclic sending of the current set-point temperature (min)
Options:
This parameter is used to specify the amount of time that will elapse before the current setpoint
value is automatically transmitted.
Note
This parameter is only available when the "Send current setpoint" is set on "Only
during change".
2.21.29 Setpoint adjustment — Maximum manual increase during heating mode (0 - 9°C)
Options:
This preset can be used to limit the manual increase during heating.
Note
This parameter is only available when parameter "Controller function" is set
on "Heating" and parameter "Control value type" on "2-point 1 bit, On/Off" or
"2-point 1 byte, 0/100%".
Product manual 2CKA001473B5023
Control elements and application parameter
Setting option between 5 - 15
Cyclic and during change
Only for change
Setting option between 5 - 240
Setting option between 0 - 9
Application "Internal RTC"
│149