Table of Contents
Advertisement
5. Cleaning for OPC drum: The cleaning brush and b
after image transfer to the paper.
6. Quenching for OPC drum: Quenching is done by i
at the end of every job.
7. Cleaning and quenching for transfer belt: The clea
grounding roller inside the transfer belt unit remov
8. ID sensors: The ID sensors detect the density of ID
sensors for the line position adjustment (front, cen
[A]: Line position adjustment (front)
[B]: Line position adjustment (center) & proces
[C]: Line position adjustment (rear)
[D]: Humidity Sensor (Internal).
The ID sensor output is used for the following:
p
- Process control and for automatic line positio
- Skew correction
- Color registration adjustments for the latent i
Service Manual
2. Product d
description
blade remove remaining toner on the drum surface
lluminating the whole area of the drum with the laser
aning brush and blade clean the belt surface. The
ves the remaining charge on the belt.
D sensor patterns on the transfer belt. Three ID
nter, and rear) and process control.
ss control
g
on
mage.
2-3
32
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
