3.15 Side joint PBA
Perform the following procedure to remove the Ozone
1. Open the side unit.
2. Release the side joint board cover after removing
2 screws.
Push !
Service Manual
3. Replacemen
nt Procedures
Filter Fan from the printer.
3. Unplug all connectors.
4. Remove 4 screws.
4 Remove 4 screws
5. Release the side joint board.
CAUTION
When you reassemble the side joint board to the
side unit, make sure the harness arrangement is
correct.
The harness on the side joint board.
The harness on the side joint board
3-5
57
The harness of Face up Sensor.
SAMSUNG ELECTRONICS