Samsung CLX-9252 Series Service Manual page 158

5. Remove 2 E-rings (gear, shaft)
6. Remove the gear [B], gear [C].
7. Remove the shaft [D] from the opposite side.
8. Remove the spring [E] from both sides.
9. Remove the left/right bracket [F] after removing 2 sc
[C] [C]
[B]
Service Manual
3. Replacemen
[F] [F]
[E]
E-ring
nt Procedures
crews from each bracket.
[D]
[D]
NOTE
When removing the springs, pull it with the
tweezers to the direction of arrow.
NOTE
When reassembling the springs, put its left side.
Then put its right side with tweezers.
Before reassembling the spring, align the CAM
position as shown below.
3-4 45
[E]
[F] [F]
SAMSUNG ELECTRONICS