Samsung CLX-9252 Series Service Manual page 246

• Diagnostics > Adjustment > Finisher Adjustm
Purpose
Operation
Procedure
Verification
Specification
Reference Reference
• Diagnostics > Adjustment > Finisher Adjustm • Diagnostics > Adjustment > Finisher Adjustm
Purpose
Operation
Procedure
Verification
Specification Specification
Reference
Service Manual
To correct hole punching positio
1. Choose one item from the
• Punch Hole DOF Position –
2. Select one item and press th 2 Select one item and press th
3. Change the adjustment valu
to lead edge, while - value
4. Press the "OK" button to ap
Print out with punch hole and ch
DOF Position Unit: mm, Scale: 0
N/A N/A
To correct stapling position.
1. Choose one item from the
• Staple STS Position (
• Front Dual Staple DOF Posi
• Rear Dual Staple DOF Posit p
2. Select one item and press t
3. Change the adjustment valu
to lead edge or rear position
front position.
4. Press the "OK" button to ap
Print out with stapling and chec
Staple STS Position Unit: mm S Staple STS Position Unit: mm. S
DOF Position Unit: mm, Scale:
STS Position Unit: mm, Scale: 0
Lead-Edge
4.Servic ce Mode
ment > Punch Hole Position
on. Only available when punch kit is installed.
table.
Direction of feeding position
he edit button he edit button.
ue with arrow button. + value moves the position
moves the position to trail edge.
ply the new value to the system.
heck the punch hole position is located as adjusted.
0.1, Min/Max: ±50mm
ment > Staple Position ment > Staple Position
e table. There are three items to choose.
ⓐ
)
ⓑ
tion ( )
) )
ⓒ
tion ( (
the edit button.
ue with arrow button. + value moves the position
n, while - value moves the position to trail edge or
pply the new value to the system.
ck the stapling position is located as adjusted.
Scale: 0 1 Min/Max: ±50mm Scale: 0.1, Min/Max: ±50mm
0.1, Min/Max: ±50mm
0.1, Min/Max: ±50mm
R Rear
ⓒ
Paper Trail-Edge
ⓑ
ⓐ
F ront
4-4 41
Finisher
Front Cover
SAMSUNG ELECTRONICS