Table of Contents
Advertisement
● Code :
M1-1213
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper has not reached the tray2 feed sensor wit
● Troubleshooting method :
1. Open the Side door. If there is a jammed paper, rem
Close the Side door. After warm up, if same jam oc
2. Install the Pick up (forward, retard )roller correctly.
3. If the pick up roller(JC93-00540A) is worn out or co
(Refer to 6.2.6 Pick up / Forward / Reverse rolle
4. Check if paper in the cassette are curled, replace th
4 Ch
k if
i th
5. Check if the wall connector of tray1 pick up unit is c
6. If the problem persists, remove the pick up
following.
(
(Refer to 3.23.1 Pick up unit.)
a. If the spring at the bottom of the pick up unit break
If the assembly mold part with spring is broken, re
b. If the compression spring of the guide-forward pick
c. If the error message displays despite paper empty
interrupt. Reassemble the empty actuator or repla
In case that the actuator is broken, check the following
I
th t th
t
1. Does the pick up (forward) roller rotate?
a. Check if the clutch connector of the pick up drive
Reconnect it.
b. Enter the diagnostic mode. Execute "clutch test"
c. If the timing belt of the pick up drive unit breaks a
g
d. Check if the motor connector of the pick up drive
e. Enter the diagnostic mode. Execute "motor test"
2. Replace the main
Service Manual
● Error message :
Paper jam in tray 2.
p,
tt
l d
p
)
t
i b k
h
k th f ll
p
p
board(JC92-02580A(for 9352) / J
7. Troubles
shooting
thin normal time after pick up.
move it.
j
curs, check the following.
,
ntaminated, replace it.
r)
l
th
he paper or stretch to remove curling.
h
connected properly. Reconnect the connector.
unit(JC9
93-00070A(1st)/
ks away or is broken, replace the spring.
eplace it.
k up breaks away, reassemble or replace it.
y in the cassette, check the empty actuator and photo
ce the photo interrupter.
i
g :
unit(JC93-00065A) is connected properly.
. If it is defective, replace it(JC47-00037A).
away or is broken, replace it.
y
unit is connected properly. Reconnect it.
. If it is defective, replace it.
JC92-02581A(for
7-7
74
g
t t h t
li
JC93-00174A(2nd)) and check the
,
p
9252))
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
