Table of Contents
Advertisement
● Code :
M2-1321
M2-1324
M2-1325
● Symptom / Cause :
y
1. The paper has not reached to the Fuser In sensor w
sensor.
2. When opening the side door, the paper is detected a
● Troubleshooting method :
1. Open the side (take away) door. Remove the jamme
Close the side (take away) door. After warm up, if sa
2. If there is any obstacles between the tray1 feed rolle
3. Check if the idle roller on bottom of the side unit is fi
3. Check if the idle roller on bottom of the side unit is fi
reassemble the idle roller.
In case of the electrical part problem, check the followi
1. Check if the reflective connector, junction connecto
Reconnect the connector.
2. Enter the diagnostic mode, and check the reflective
If the paper is at sensor and "Without paper" messa
3. Enter the diagnostic mode, and check the motor tes
If the motor is broken, replace it. (JC31-00132A)
4. Check if the regi connector of main board is connec
5. Replace the main
Service Manual
● Error message :
Paper jam inside of m
board(JC92-02580A(for 9352) / J
7. Troubles
shooting
machine.
within a regular time after passing the registration
at the Fuser In Sensor.
ed paper.
ame jam occurs, check the following.
er and the regi roller, remove it.
ixed correctly. If or not, disassemble the Guide and
ixed correctly. If or not, disassemble the Guide and
ing :
or on the middle of regi roller are connected properly.
sensor test.
ge is displayed, replace the sensor.
t of the pick up drive unit.
ted properly. Reconnect it.
C92-02581A(for
7-7
78
9252))
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
