Table of Contents
Advertisement
11.5.14 Application - 2-button blind
The application makes it possible to control blinds and roller blinds via a button pair.
The following communication objects are available:
"Sx: moving" (1-bit object)
■
"Sx: adjusting" (1-bit object)
■
"Sx: position" (1-byte object)
■
"Sx: slats" (1-byte object)
■
The application is used to specify whether the first or second button triggers the "Up" or "Down"
movement command. Also Up and Down positions as well as slat position can be preset.
Movement and slat adjustment commands are sent to linked blind actuators with long and short
button operations. A long press of the button triggers a move command. A short press of the
button triggers a command to adjust the slats.
The sensor stores the last command carried out with the button that is occupied with the
application. This means, for example, if a blind was lowered and halted at half height via a short
press of the button, then a renewed long press of the button will raise the blind.
The application makes a joint set of parameters and communication objects available in function
block x for both buttons.
Note
The parameters for application "2-button blind" can be called up via general
parameters and extended parameters.
Note
The number (S1 - Sx) of the object depends on the function block and the button
number.
Product manual 2CKA001473B9488
Description of application and parameters
Application "Function block x"
│116
Advertisement
Table of Contents
