Ball Valve; Straight-Barbed Fitting (1-1/4 Inch Npt X 3/4 Inch); Valve-Mount Bracket; Hex-Head Bolt (5/16 X 5/8 Inch) - Toro Multi Pro 1750 Operator's Manual

6. Remove the plastic tie that secures the rinse tank
connector to the wiring bundle and route the connector
to the opening that you made in the console.
7. Through the opening in the console, connect the 8-pin
connector of the 3-position rocker switch into the
8-socket rinse tank connector
8. Push the switch into the opening in the console until
the switch snaps into position.
Connecting the Rinse Pump Connector
1. Align the 2-socket electrical connector of the wiring
harness for the machine with the 2-pin electrical
connector for the rinse pump
Figure 30
1. 2-socket electrical
connector (machine wiring
harness)
2. Press the 2 connectors together until the latch in the
2-socket connector snaps securely
Installing the Fuse
1. At the fuse block, remove the 30 amp fuse
(Figure 29).
(Figure 30).
2. 2-pin electrical connector
(rinse-pump harness)
(Figure 30).
(Figure 31).
2. At the same socket that you removed the 30 amp fuse,
insert a 40 amp fuse
3. Connect the positive battery cable to the battery
(Figure 28).
4. Lower the operator's seat
7
Installing the Ball Valve and
Mounting Assembly
Parts needed for this procedure:
1

Ball valve

2

Straight-barbed fitting (1-1/4 inch NPT x 3/4 inch)

1

Valve-mount bracket

2

Hex-head bolt (5/16 x 5/8 inch)

2

Hex-head bolt (6 x 16 mm)

2

Locknut (6 mm)

Procedure
Note: Apply PTFE tape to the threads of the taper-threaded
fittings used in the sprayer and rinse systems.
1. At the boom-mounting plate for the right frame
channel of the machine, measure rearward 15.2 cm (6
inches) and mark a line across the right boom mount
that supports the center-boom section
16
Figure 31
(Figure 31).
(Figure 28).
(Figure 32).