Toro Multi Pro 1750 Operator's Manual page 7

1. Fresh water tank
2. Mounting bracket
3. Remove the tank from the machine
Note: Retain the fresh water tank and flanged head
bolts for installation in
(page 10).
Installing the Hardware for the Rinse
Tank Straps and Spray Gun Bracket
1. Assemble the 2 clamps to the spray-gun bracket
4) with 2 carriage bolt (5/16 x 1 inch) and 2 flanged
locknuts (5/16 inch).
1. Carriage bolt (5/16 x 1
inch)
2. Spray-gun bracket
2. Remove and retain the bolt (3/8 x 5 inch), washers, and
flanged locknut that secure the front tank straps at the
top of the tank (Figure
Figure 3
3. Flanged head bolts
(Figure 3).
Installing the Fresh Water Tank
Figure 4
3. Clamp
4. Flanged locknut (5/16
inch)
5).
Note: Retain the bolt (3/8 x 5 inch), washers, and
flanged locknut; discard the short carriage bolt and
locknut holding the R-clamp in place.
1. Locknut
2. R-clamp
3. Carriage bolt (short)
4. Bolt (3/8 x 5 inch)
3. Install a carriage bolt (3/8 x 1 inch) in the upper-inboard
(Figure
holes of the left, front tank strap
Note: Loosely thread a flanged locknuts (3/8 inch)
onto the carriage bolt.
1. Flanged locknuts (3/8
inch)
2. Carriage bolt (3/8 x 1 inch)
7
Figure 5
5. Washer
6. Flanged locknut
7. Right, front tank strap
(Figure 6).
Figure 6
3. Carriage bolts (3/8 x 1-1/4
inch)