Operation
Tank Clean Rinse Kit Operation
Using the Tank Clean Rinse Kit creates a rinsate; a diluted solution of residual chemicals. In many cases it is appropriate to
apply the rinsate onto the treated areas. However, before doing so, check with the manufacturer of the chemical to ensure that
the application of a diluted solution to the treated areas will not adversely affect the performance of the product.
Important: The Tank Clean Rinse Kit is not intended to dislodge clumped masses of wetable powder or
"water-soluble" chemicals that occur when chemicals are not properly introduced into the main tank.
Configuring the Valves for the Rinse System
Note: Do not set the valves in any other configuration except those shown below.
•
This is the tank rinsing configuration
in the tank.
Note: The ball valve must be in this position when using the spray system.
•
This is the spray gun configuration
Note: The ball valve must be in this position when using the spray system.
(Figure
53). Use this configuration to spray rinse water out of the rinse nozzles
Figure 53
4–way valve + Ball Valve
(Figure
54). Use this configuration to spray rinse water out of the hand spray gun.
Figure 54
4–way valve + Ball Valve
26