Toro Multi Pro 1750 Operator's Manual page 8

4. Install 1 carriage bolt (3/8 x 1-1/4 inch) in the
upper-inboard holes of the right, front tank strap
(Figure 6).
Note: Loosely thread a flanged locknuts (3/8 inch)
onto the carriage bolt.
5. Install 1 carriage bolts (3/8 x 1-1/4 inch) in the
lower-outboard holes of the right, front tank strap
(Figure 6).
Note: Loosely thread a flanged locknuts (3/8 inch)
onto the carriage bolts.
6. Install the tank strap hardware that you removed in
to secure the straps to the tank.
Note: Ensure that the square portion of the carriage
bolts are seated in the square opening in the tank straps.
Note: Make sure that the straps are flush to the tank.
Do not overtighten tank strap hardware.
7. Remove the flanged locknut (3/8 inch) at the
lower-outboard carriage bolt at the right, front tank
strap, assemble the spray gun bracket to the carriage
bolt, and secure the bracket with the flanged locknut
(Figure 7).
Figure 7
1. Carriage bolts (3/8 x 1-1/4
inch)
2. Flanged locknut (3/8 inch)
3. Spray-gun bracket
Installing the Tank
1. Install the bulkhead fitting into the rinse tank as
follows:
A. Install the flanged seal onto the bulkhead fitting
(Figure
2
1. Bulkhead fitting
2. Retaining-fork hole
B. Attach a wire, longer than the tank is tall, to one
of the retaining-fork holes in the bulkhead fitting
(Figure 8
2
1
1. Rinse tank
2. Filler cap
3. Bulkhead fitting
C. Remove the tank cap, insert the wire through the
filler neck, and pass the wire out through the
outlet at the bottom of the tank
D. Use the wire to guide the bulkhead fitting to the
outlet (Figure
8
8).
Figure 8
3. Flanged seal
and Figure 9)
3
4
6
Figure 9
4. Filler opening, rinse tank.
5. Wire
6. Outlet (bottom of the tank)
(Figure
10).
5
G014228
9).