Rinse Nozzle; Bushing; Rinse Vane; Shoulder Bolt - Toro Multi Pro 1750 Operator's Manual

3
Installing the Rinse Nozzles
Parts needed for this procedure:
2 90° barbed fitting (3/4 inch NPT x 3/4 inch)
2 Plastic flange nut
2 Bulkhead fitting
2

Rinse nozzle

2

Bushing

2

Rinse vane

2

Shoulder bolt

Drilling the Main Tank
1. Open the tank lid and remove the strainer basket.
2. Locate the 2 drill marks on the main tank
G022212
Figure 16
1. Drill marks
3. Use a 4 cm (1-5/8 inch) hole saw to drill a hole at each
drill mark.
Note: Place a receptacle inside the tank and below the
areas to be drilled to catch any debris created during
the cutting.
Important: Debris left inside a tank could clog
and damage the spray system during operation.
Note: Drilling counter clockwise will make drilling
easier.
(Figure 16).
1
Installing the Nozzles
Note: Apply PTFE tape to the threads of the taper-threaded
fittings used in the sprayer and rinse systems.
1. Assemble the 2 rinse nozzles as shown in
1
2
3
4
5
1. Bulkhead fitting
2. Rinse nozzle
3. Bushing
2. Open the cover of the sprayer tank.
3. Assemble the nozzle assemblies up through the drilled
holes (Figure 18).
1
2
3
1. Bulkhead fitting
2. Plastic flange nut
4. At top of the tank, install the plastic flange nuts over
the exposed threads of the bulkhead fittings for the
rinse nozzles(Figure
Note: Ensure that the seal is seated flush between the
bulkhead fitting and the underside of the tank.
11
Figure
G022281
Figure 17
4. Rinse vane
5. Shoulder bolt
G022282
Figure 18
3. Rinse-nozzle assembly
18).
17.