Plastic Flange Nut; Bulkhead Fitting - Toro Multi Pro 1750 Operator's Manual

1
Preparing the Machine
No Parts Required
Procedure
1. Move the sprayer onto a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2. Drain the contents of the tank to remove any chemicals
in the lines. Refer to the Operator's Manual for more
information.
Note: Take caution while disconnecting any hoses
during the installation of this kit, and have a catch
bucket ready for any chemicals remaining in the hose.
CAUTION
Chemicals are hazardous and can cause personal
injury.
• Read the directions on the chemical labels
before handling the chemicals, and follow
all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin. Should
contact occur, wash the affected area thoroughly
with soap and clean water.
• Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
2
Installing the Rinse Tank
Parts needed for this procedure:
2 Carriage bolt (5/16 x 1 inch)
1 Spray-gun bracket
2 Clamp
2
Flanged locknut (5/16 inch)
1 Carriage bolt (3/8 x 1 inch)
2 Carriage bolt (3/8 x 1-1/4 inch)
3 Flange locknut
1 Rinse tank
1 Filler cap
1

Bulkhead fitting

1

Plastic flange nut

1 Retainer
1 90-degree barbed fitting
1 Right rinse-tank bracket
1 Hose mount
1 Left rinse-tank bracket
1 Spacer (3/8 x 1/4 inch)
Removing the Fresh Water Tank
1. If filled with water, empty the fresh water tank.
2. Remove the 4 flanged head bolts that secure the fresh
water tank to the mounting bracket
6
(Figure 3).