Toro Multi Pro 1750 Operator's Manual page 18

8
Installing the Upper Tee
Assembly
Parts needed for this procedure:
1 Inlet hose 2.5 x 66 cm (1 x 26 inch)
2 Hose clamp
2 90° hub fitting
4 Large O-ring
1 T-Fitting (upper)
3 Retainer
1 Reducer hub
1 Small O-ring
1 Transfer hose 1.9 x 61 cm (3/4 x 24 inch)
1 Hub connector
Removing the Inlet Hose
1. Remove the flange clamp, gasket, flanged elbow, and
inlet hose from the pressure filter head (A of
Note: Retain the gasket and flange clamp for
installation later.
Figure 35).
1. Inlet hose assembly
2. Flanged elbow (machine)
3. Flange clamp
4. Gasket
2. Remove the retainer that secures the straight-hub
fitting of the inlet hose to the lower T-fitting of the
sprayer system and remove the inlet hose from the
machine (B of
Note: Retain the retainer for installation in
the Upper T-fitting and Inlet Hose (page
3. Remove the flanged elbow and hose clamp from the
inlet hose
Note: Retain the flanged elbow and hose clamp;
discard the old inlet hose and straight-barbed fitting.
18
Figure 35
5. Pressure filter head
6. Retainer
7. Lower T-fitting
8. Straight-hub fitting (inlet
hose)
Figure 35)
(Figure 35).
Installing
20).