Toro Multi Pro 1750 Operator's Manual page 23

12
Installing the Rinse Nozzle
Hoses
Parts needed for this procedure:
2 Hose 1.9 x 48.3 cm (3/4 x 19 inch)
1
Hose 1.9 x 61 cm (3/4 x 24 inch)
1 Tee fitting
6 Hose clamp
Procedure
Note: To insert the barbed fitting into the hose more easily,
apply a light coat of a non-petroleum-based lubricant, such as
vegetable oil to the barbed end of the fitting.
1. Assemble a hose 1.9 x 48.3 cm (3/4 x 19 inch) onto
each of the 90° barbed fittings at the 2 rinse nozzles
(Figure 45).
Figure 45
1. 90° barbed fittings (rinse
nozzle)
2. Hose clamp
2. Secure the hoses to the 90° barbed fittings with hose
clamps (Figure 45).
3. Insert the barbed T-fitting into free end of each hose
(Figure 45).
4. Align the barbed T-fitting so that the side of the lower
barb is flush to the sprayer tank and secure the hoses
to the T-fitting with 2 hose clamps
5. Assemble a hose 1.9 x 61 cm (3/4 x 24 inch) over the
straight-barbed fitting at the forward side of the 4-way
valve (Figure 46).
3. Hose 1.9 x 48.3 cm (3/4 x
19 inch)
4. Barbed T-fitting
(Figure 45).
1. Hose clamp
2. Barbed T-fitting
6. Secure the hose to the fitting at the valve with a hose
clamp (Figure 46).
7. Assemble the free end of the hose onto the barbed
T-fitting and secure the hose to the fitting with a hose
clamp (Figure 46).
23
Figure 46
3. 90° barbed fitting
4. Hose 1.9 x 61 cm (3/4 x
24 inch)