Table of Contents
Advertisement
10.24.58 Additional cooling stage — Cyclic sending of the control value
Options:
The current control value used by the device can be cyclically transmitted to the bus.
Notice
This parameter is only available when the "Control value type" parameter is set
either on "2-point 1 Bit, Off/On, "2-point 1 Byte, 0/100%", "PI continuous, 0-
100%" or "Fan coil".
10.24.59 Additional cooling stage — Maximum control value (0 - 255)
Options:
The maximum control value of the PI controller defines the maximum value outputted by the
controller. If a maximum value under 255 is chosen, the value will not be exceeded, even if the
controller calculates a higher control value.
Note
This parameter is only available when "Control value type" parameter is set
either on "PI continuous, 0 – 100%", "PI PWM, On/Off" or "Fan coil".
10.24.60 Additional cooling stage — Minimum control value for basic load (0 - 255)
Options:
The minimum control value of the PI controller defines the minimum value output by the
controller. If a minimum value greater than zero is chosen, the controller will not output a lower
value, even if it calculates a value that is lower. This parameter can be used to set a basic load,
e.g. for operating surface cooling. Even if the controller calculates the control value zero, a
cooling medium will flow through the cooling area to prevent the floor from heating up. Under
"Settings of basic load", it is also possible to define whether this basic load will be permanently
active or whether it will be switched by the "Basic load" object.
Note
This parameter is only available when "Control value type" parameter is set
either on "PI continuous, 0 – 100%", "PI PWM, On/Off" or "Fan coil".
Product manual 2CKA001473B5343
KNX control elements and application parameters
00:01:00 - 01:00:00
Setting option between 0 - 255
Setting option between 0 - 255
Application "Internal RTC"
│251
Hide quick links:
Advertisement
Table of Contents
