Table of Contents
Advertisement
6
About IP1200 Appliance ADP Services Modules
Installing and Replacing ADP Modules
Note
Before you begin this procedure, you should review all ADP module information in the Nokia
Getting Started Guide and Release Notes for the version of Nokia IPSO you are using and
refer to both of these documents as needed as you complete the installation and
configuration process.
Use these instructions to install an ADP module in your appliance.
Before You Begin
To install a Nokia ADP module, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Nokia Network Voyager or the CLI
A suitable, grounded work surface
The ADP module kit
To install an ADP module in IP1220 and IP1260 appliances
Use the procedures included in the Nokia IP1200 Series Security Platform Installation Guide or
the Nokia IP1220 and IP1260 Security Platforms Installation Guide to install or replace Nokia
ADP module in your appliance. There are few differences between the procedures for installing
and replacing IP1200 PMC NIC card carriers and the ADP module other than the following
steps and considerations:
Before you remove your PMC NIC card carriers and replace them with your ADP module,
do the following:
You cannot preserve the configuration for slots 1 and 2 of your appliance when you
replace your PMC NIC card carriers with an ADP module or, conversely, when you
replace your ADP module with PMC NIC card carriers due to interface naming
convention differences. Therefore, you need to delete all existing configurations
associated with slots 1 and 2.
Upgrade the Nokia IPSO software to the required version as described in the Nokia
Getting Started Guide and Release Notes that you received with your ADP module.
You need to have both slots free to install the ADP module, as the module occupies both
slots. That is, you must first remove any installed PMC card carriers. For the card carrier
removal procedure, see the IP1200 Series Security Platform Installation Guide or the Nokia
IP1220 and IP1260 Security Platforms Installation Guide.
Note
You must first power down your IP1220 or IP1260 appliance before you remove any
installed card carriers.
68
All manuals and user guides at all-guides.com
IP1220 and IP1260 Security Platforms Installation Guide
Advertisement
Table of Contents
