Before You Begin - Nokia IP1220 Installation Manual

Before You Begin

To replace the encryption accelerator card, you need:
Physical access to the appliance
The Nokia encryption accelerator card and installation kit
Phillips-head screwdriver
Four screws (included in kit)
Disposable wrist strap (included in kit)
Caution
To help guard against electrostatic discharge damage, make sure you are properly
grounded by using a grounding wrist strap and following the instructions provided with
the wrist strap before you handle the components or open the appliance. The
grounding plug on the front of the appliance (shown in
chassis grounding point. If you do not have a grounding wrist strap, make sure you are
properly grounded before you touch any electronic component.
Note
Because power to an IP1200 Series is automatically disconnected when the chassis tray
assembly is opened, you do not need to manually disconnect the power for this procedure.
Any servicing of the appliance, however, should be completed with the chassis tray
assembly fully removed from the appliance.
To install the encryption accelerator card
1. Use Nokia Network Voyager or Lynx to shut down the IP1200 Series.
For information about how to access Network Voyager and the related reference materials,
see "Using Nokia Network Voyager"
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
Installing a Nokia Encryption Accelerator Card
Figure 1 on page 20) provides a
on page 44.
103