All manuals and user guides at all-guides.com
6
About IP1200 Appliance ADP Services Modules
The following figure shows the VRRP configuration:
The rest of this section describes how to reconfigure the interfaces and VRRP to accommodate
the ADP interfaces.
Deleting VRRP Configurations
After you physically remove PMC NIC card carriers that you are replacing with an ADP
module, you need to delete the configuration information for the NIC interfaces. If VRRP is
active at that time, you will not be able to delete the configuration information for the interfaces
used by VRRP. Therefore, you should begin by deleting the existing VRRP configuration.
Note
It is best to perform the procedures in this section on the VRRP backup system first. When
the installation is complete, the upgraded system can become the new master while you
upgrade the original master.
74
IP1220 and IP1260 Security Platforms Installation Guide