Table of Contents
Advertisement
6
About IP1200 Appliance ADP Services Modules
These changes can affect any features or protocols that use the existing interfaces or their
addresses, including the following:
Dynamic routing protocols
Multicast routing protocols
Static routing configuration
VRRP
IP clustering
Transparent mode
Link aggregation
Link redundancy
Traffic management/QoS
Note
After you install an ADP module, reconfigure any protocols and features that used the
removed interfaces to use the ADP interfaces. Reassign IP addresses from the removed
interfaces to the ADP interfaces as appropriate.
Nokia ADP Card Interface Names for IP1220 and IP1260
Appliances
ADP module interface naming conventions differ from those for PMC NICs
IP1220 and IP1260 appliances support one ADP module, which you install in slots 1 and 2. The
eight ports on your ADP module are named as follows:
eth-s2p1, eth-s2p2, eth-s2p3, eth-s2p4, eth-s2p5, eth-s2p6, eth-s2p7, eth-s2p8
Since the ADP interface names are not exactly the same as other PMC NIC interface names, you
need to reconfigure your appliance when you replace PMC NICs with an ADP module or an
ADP module with PMC NICs.
72
All manuals and user guides at all-guides.com
IP1220 and IP1260 Security Platforms Installation Guide
Advertisement
Table of Contents
