Table of Contents
Advertisement
5
About IP1200 Series Appliance Network Interface Cards
Two-Port Fiber-Optic Gigabit Ethernet NICs
The IP1200 supports Nokia-approved, two-port, fiber-optic Gigabit Ethernet NICs installed on a
PMC expansion slot. The IP1200 can accommodate up to four Gigabit Ethernet NICs.
When you purchase a Gigabit Ethernet NIC with your IP1200, the NIC is installed before the
appliance is delivered to you. For information about how to add or replace a NIC, see
"Installing and Replacing Network Interface Cards and Accelerated Data Path (ADP) Services
Modules."
Fiber-Optic Gigabit Ethernet NIC Features
The short-range and long-range fiber-optic Gigabit Ethernet NICs support:
High bandwidth
Full-duplex mode operation up to 1 Gbps (no half-duplex support)
Link speed auto advertising
Tracing through tcpdump
Compliance with IEEE 802.3z Gigabit Ethernet specification
The short-range multi-mode fiber (MMF) fiber-optic Gigabit Ethernet NICs in the IP1200 run
on Nokia IPSO v4.0.1 or higher.
The long-range single-mode fiber (SMF) fiber-optic Gigabit Ethernet NICs in the IP1200 run on
Nokia IPSO v4.2 or higher.
You can configure and monitor Gigabit Ethernet NIC interfaces with Nokia Network Voyager.
Specifically, you set the port speed and full-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related reference materials, see
"Using Nokia Network Voyager"
Figure 19
Gigabit Ethernet NIC you can use in IP1200 appliance.
Figure 19 PMC Two-Port Short-Range Gigabit Ethernet NIC
64
All manuals and user guides at all-guides.com
on page 44.
shows the front panel details for the two-port short-range (1000 BASE-SX) fiber-optic
Ports
Link LEDs (solid green)
Activity LEDs (blinking amber)
IP1220 and IP1260 Security Platforms Installation Guide
Chapter 4,
00206
Advertisement
Table of Contents
