Table of Contents
Advertisement
The PKCS#11 token that enables IKE acceleration is registered with the Check Point software
on your appliance. After you register the module, you must install the Check Point security
policy on the firewall for the Nokia encryption accelerator card to perform IKE acceleration.
Installing a Fan Unit
The fan unit is hot swappable. You can remove and install the fan unit on the back of the IP1200
Series without shutting the appliance down.
Before You Begin
To replace a fan unit, you need:
Physical access to the IP1200 Series appliance.
Replacement fan unit kit and appropriate documentation.
Caution
Components inside the appliance can overheat if they are not cooled even for a short
period of time. If you are replacing a failed fan unit, and do not completely remove power
to the appliance, do not allow the appliance to run without a fan unit for any longer than
necessary.
To replace a fan unit
1. Locate the fan unit on the back of the IP1200 Series appliance and the four retaining screws
that secure it.
2. Loosen the retaining screws by turning them counterclockwise.
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
Installing a Fan Unit
Fan unit
00308a
107
Advertisement
Table of Contents
