Configuration Example With Vrrp - Nokia IP1220 Installation Manual

Configuration Example with VRRP

This example describes the steps required to install an ADP module in an IP1220 or IP1260
appliance with VRRP configured. The following figure shows the Interface Configuration page
of the platform before an ADP module is installed. Interfaces are installed in slots 1, 2, and 3.
For this example, legacy monitored-circuit VRRP is enabled and configured with these settings:
Interface eth-s1/s1p1c0 is assigned the IP address 10.1.1.1 (not shown) and uses 10.1.1.99 as
the VRRP backup address.
Interface eth-s1/s1p2c0 backs up interface eth-s1/s1p1c0.
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
Configuring Nokia IPSO for IP1220 and IP1260 ADP Interfaces
73