Table of Contents
Advertisement
Figure 12 Four-Port 10/100 Ethernet NIC Front Panel Details
After the power is turned on and the cables are connected, the Ethernet link LEDs on both the
IP1200 Series and on the remote equipment illuminate to indicate the connection. As data is
transmitted, the activity LEDs on the appliance illuminate.
Ethernet NIC Connectors and Cables
The Ethernet connectors on the two-port and four-port 10/100 Ethernet NICs are RJ-45
connectors. Use a straight-through cable to connect the NIC to a 10-Mbps or 100-Mbps hub or
switch, or a crossover cable to connect directly to a host.
Use IEEE 802.3 10/100 BASE-TX Cat 5 unshielded twisted-pair, full-duplex, or half-duplex
cable. You can order appropriate adapter cables separately from a cable vendor of your choice.
Caution
Cables that connect to the Ethernet card must be IEEE 802.3 compliant to prevent
potential data loss.
Figure 13
to left, with the copper tabs facing up and toward you.
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
1
1
2
3
4
Link LED (solid green)
Activity LED (blinking green)
shows the pin assignments for the RJ-45 cable. The connector is numbered from right
Four-Port 10/100 Ethernet NICs
Ports
RJ-45 connectors
2
3
4
00641
59
Advertisement
Table of Contents
