Figure 10 Power Switch Location - Nokia IP1220 Installation Manual

Figure 10 Power Switch Location

Caution
To avoid potential service interruptions from momentary facility power interruptions and
potential power spikes that might damage your equipment, Nokia strongly recommends
that you use an uninterruptible power supply (UPS) with surge protection with your
IP1200 Series appliance.
To connect the power supply
1. Connect the power cord securely into the power cord receptacle on the power supply.
2. Plug the other end of the power cord into a three wire grounded power strip or wall outlet.
3. Toggle the 1/O power switch to the 1 position to provide power to the IP1200 Series
appliance.
The fan unit on the power supply turns on when you press the power switch. Verify that the
power supply fans are running after you press the switch.
Note
The IP1200 Series appliance power supply automatically detects the input voltage (115
VAC or 220 VAC [85 to 264]) and configures itself appropriately.
4. Check the power LED (the Nokia logo) on the front panel of the appliance to ensure that the
power supply is operating correctly.
The power LED should be illuminated. For more information about the system status LEDs, see
"System Status LEDs"
If the fans are not running, or if the power LED is not illuminated, make sure:
The power cord is properly connected.
The power supply switch is on.
The chassis tray assembly is pushed all the way in from the front of the appliance.
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
Power supplies
Power cord receptacle
on page 23.
Connecting Power and Turning the Power On
Power switch
00308a
41