4
9600 bps
8 data bits
No parity
1 stop bit
To connect to the console
1. Connect the supplied null-modem cable (console cable) to the console port on the front
panel of the IP150 appliance.
If you connect the console port to a data communications equipment (DCE) device, use a
straight-through cable.
For cable pin assignments for the console connection, see
2. Connect the other end of the cable to the VT100 console or to a system running a
terminal-emulation program.
Connecting Power and Turning the Power On
A power switch and a receptacle for the power cord are located on each power supply on the
back of the appliance as shown in
Figure 10 Power Switch Location
26
POWER
STATUS
FAULT
AUX
CON SOLE
Console port
Figure
10.
Check Point IP150 Security Platform Installation Guide
1
2
3
4
Figure 4
Power plug
IP150
00662
on page 13.
00663
Power switch