Figure 2: imagePRESS Server connector panel
1 USB ports (x6)
2 Power connector
3 Network port
4 Scan crossover connector (10/100 BaseT)
5 Printer interface connector
6 Duct
7 Power switch
Steps to integrate the imagePRESS Server into your network
This procedure provides an overview of the steps required to integrate the imagePRESS Server into your network
and print environment.
Warning: Ensure all cables remain routed to prevent trip hazards and to prevent accidental disconnection or
damage. Ensure that the cables are not compressed, pinched, or bent at a sharp angle. Damaged cables can
result in electric shock to personnel, in addition to faulty operation of the equipment.
Caution: Use caution and correct ergonomic procedures if it is necessary to lift or move the imagePRESS
Server or connected equipment.
Important: If you are concerned about the possibility of information being extracted from the imagePRESS
Server Ethernet port without authorization, consider securing the Ethernet port.
Important: For the power connection to the imagePRESS Server, only use the power cable provided with the
imagePRESS Server. Do not use a power cable intended for any other electronic device.
Configuration and Setup
Integrating the imagePRESS Server into your network
20