Huawei TP3106 Commissioning Manual page 166

HUAWEI TP3106&TP3118&TP3118S
Commissioning Guide
1.
2.
3.
Step 4 Set the manual focus value.
1.
2.
Step 5 Set the aperture.
Set Aperture VAL (value range: 0–15) to the standard value 8 by running the following
command:
camera setc500Cameraparm aperture:8 camport:5
Issue 01 (2015-02-12)
Backlight compensation (standard value: 0)
Run the backlight command to turn on or off backlight compensation (0: off; 1: on). The
command format is as follows: camera setc500Cameraparm backlight:0 camport:5
Generally, you do not need to change the settings of this parameter.
Shutter speed (standard value: 6)
Run the speed command to set Shutter speed (value range: 1–15). The command format
is as follows:
camera setc500Cameraparm speed:6 camport:5
Note: If the screen blinks, set Shutter speed to 8.
Shutter delay (standard value: 0)
Run the slowshtlimit command to set ShutterLimit VAL (value range: 0–2). The
command format is as follows:
camera setc500Cameraparm slowshtlimit:0 camport:5
Generally, you do not need to change the settings of this parameter.
Set the focus mode to manual focus by running the following command:
camera setc500CameraParam focusswitch:1 camport:5
Set Focus VAL to the standard value 9000 by running the following command:
Camera setc500CameraParam focusval:9000 camport:5
See the following figure.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Appendix
158