Lubrication - Toro 07068 Operator's Manual

Lubrication

Service Interval: Every 50 hours
The sweeper has 11 grease fittings that require lubrication
with No. 2 lithium grease. If the machine is operated
under normal conditions, lubricate all bearings and bushings
immediately after every washing. Lubricate the bearings
and bushings daily when operating conditions are extremely
dusty and dirty. Dusty and dirty operating conditions could
cause dirt to get into the bearings and bushings, resulting in
accelerated wear.
1. Lubricate the following grease fittings:
•
Hopper pivot (upper) (2)
•
Brush pivot (2)
•
Lift cylinder (2)
•
Hopper pivot (lower) (2)
•
Hitch tongue pivot (1)
•
Windrow blade mount
•
Windrow blade hub
2. Wipe grease fittings clean so thatforeign matter cannot
be forced into the bearing or bushing.
3. Pump grease into the bearing or bushing.
4. Wipe up excess grease.
(Figure 32).
(Figure 33).
(Figure 34).
(Figure 35).
(Figure 36).
(Figure 37).
(Figure 37).
Figure 32
Figure 33
28
Figure 34
Figure 35
Figure 36