Table of Contents
Advertisement
11
Assembling the Handheld
Remote
Parts needed for this procedure:
1
Handheld remote
4
Battery (AAA)
6
Screws, small
Procedure
1. Remove the rubber bands securing the remote halves
together, and remove the back cover.
2. Plug each battery into a terminal cradle observing
proper polarity
(Figure
Note: If the batteries are improperly installed, the unit
will not be damaged, but it will fail to operate. The
cradle is embossed with polarity markings for each
terminal.
Figure 16
1. Screw
2. Cover
3. Seal
3. Ensure that the steel gasket and rubber seal are seated
in the channel in the remote and set the back cover
in place
(Figure
16).
4. Secure the cover with 6 screws
them to 1.5 to 1.7 N-m (13 to 15 in-lb).
Note: Do not over tighten the screws.
16).
4. Steel gasket
5. Batteries
6. Handheld remote
(Figure
16) and torque
16
Advertisement
Table of Contents
