Table of Contents
Advertisement
Adjusting the Front Flap
Height
For best debris pickup results, adjust the front flap
21) with a 6 mm to 13 mm (1/4 inch to 1/2 inch) clearance
between the bottom of the flap and surface.
Note: Raising the front flap all the way or removing the
front flap may be required when picking up larger debris or if
debris is to be picked up in long grass.
1. Front flap
1. Loosen the nuts securing the metal strap and the front
flap to the brush housing
1. Front flap
2. Adjust the front flap to the desired operating height
and tighten the nuts.
Checking the Tire Pressure
Check the tire pressure daily to ensure they are inflated
properly.
Correct tire air pressure: 86.2 kPa (12-1/2 psi.)
Maximum tire air presssure: of 124 kPa (18 psi)
Note: The valve stem is located on the back side of the rim.
Figure 21
(Figure
22).
Figure 22
2. Metal strap
Checking the Wheel Lug Nut
Torque
(Figure
WARNING
Failure to maintain proper torque could result in
failure or loss of wheel and could result in personal
injury.
Check and torque the wheel lug nuts to 95-122 N-m (70-90
ft-lb).
1. Lug nut
Activating the Controller
The controller
sweeper harness into the vehicle power harness.
•
On Workman models with serial numbers prior to
899999999, the harness will have power.
•
On Workman models with serial numbers 900000001 and
up, turn the ignition key to the
the harness.
1. Controller
22
Figure 23
(Figure
24) is activated as soon as you plug the
RUN
Figure 24
position to power
Advertisement
Table of Contents
