Table of Contents
Advertisement
Troubleshooting
Condition
The sweeper is not
picking up debris.
The sweeper has
excessive vibration.
The diagnostic light on
the sweeper does not
illuminate when pressing
a remote button.
Checking Fault Codes
If the diagnostic light indicates that there is a system fault (refer to
what is wrong with the machine.
Possible Causes
The brush is damaged.
The brush height is too high.
The Front flap height is too low or too high.
Check the bearings on the brush shaft. If they are
excessively hot, check the bearings for damage.
Foreign materials are wrapped around brush.
There is frequency interference.
Replace brush.
Adjust brush height. See Brush Height Adjustment.
Adjust front flap height. See Front Flap Adjustment
Replace any damaged bearings.
Clean off any foreign objects.
Associate the remote control to the base unit. Refer
to
Associate the Remote Control and the Base Unit
(page
29).
(page
)), check the fault codes to determine
31
Corrective Action
Advertisement
Table of Contents
