Product Overview; Controls - Toro 07068 Operator's Manual

Product Overview

Controls

Hopper Dump Button
To dump the hopper, press the hopper dump button 2 times
(Figure 17).
Important: The sweeper must be directly behind the
tow vehicle and in transport height before the dump
sequence can be activated.
Figure 17
1. LED light
2. Off-set left
3. Sweeper down
4. Hopper dump
Sweeper Down Button
To lower the hopper, press the sweeper down button
17). The hopper can be lowered when it is at any of the
following positions:
•
Hopper dump height
•
Transport height
•
Turn around height
Note: When lowering the hopper from the dump
position, the lower hopper function can be stopped at any
time by releasing the sweeper-down button.
Note: With the sweeper in the transport or turn-around
positions, the lower hopper function can be stopped at
any time by pressing the sweeper up button.
Sweeper Up Button—Standard Mode
To raise the sweeper in standard mode, press the sweeper-up
button. The hopper will stop at the pre-defined height
(Figure 17).
5. Stop
6. Sweeper up
7. Off-set right
(Figure
•
Transport height (home position) is 13–1/4 to 15–1/4
inches.
•
Turn around height (off-set position) is 8–1/2 to 10–1/2
inches.
Sweeper Up Button—Optional Mode
This mode allows the operator to adjust the sweeper to any
desired height and it stops at the pre-defined heights.
Note: Refer to
Switching the Sweeper-Up Mode (page 25)
switch to the optional mode.
To raise the sweeper in optional mode, press and hold the
sweeper-up button until the hopper reaches the desired height
or stops at the pre-defined height
•
Transport height (home position) is 13–1/4 to 15–1/4
inches.
•
Turn around height (off-set position) is 8–1/2 to 10–1/2
inches.
Off-Set Left Button
To off-set the sweeper to the left, press and hold the off-set
left button (Figure 17). Releasing the button will stop the
movement to the left.
Off-Set Right Button
To off-set the sweeper to the right, press and hold the off-set
right button (Figure 17). Releasing the button will stop the
movement to the right.
Stop Button
Pressing the stop button will disable any active function.
Note: There is approximately a 3 second delay.
17
to
(Figure 17).