Table of Contents
Advertisement
Maintenance
Lubrication
Idler Arm Bearing
The idler arm bearing (Figure 10) must be lubricated
after every 8 hours of operation with a No. 2
Lithium-based grease.
Figure 10
Overrunning Clutch Pulley
The overrunning clutch pulley (Figure 10) must be
lubricated after every 8 hours of operation with a No. 2
Lithium based grease.
Fan Shaft Bearing
The 2 fan shaft bearings (Figure 10 and Figure 11) must
be lubricated after every 8 hours of operation with a No.
2 Lithium-based grease.
Castor Wheels
Under normal conditions, grease the 2 wheels and 2
wheel pivot tubes (Figure 11) after every 50 hours of
use. Use a No. 2 Lithium-based grease
Lift Arm Pivots
The (2) lift arm pivots (Figure 12) must be lubricated
after every 8 hours of operation with a No. 2 Lithium
based grease
Drive Shaft and Guards
Under normal conditions, grease the (2) drive shaft
fittings after every 100 hours of use and the guards after
every 8 hours of operation (Figure 13). Use a No. 2
Lithium-based grease.
12
Figure 11
Figure 12
Advertisement
Table of Contents
