Table of Contents
Advertisement
1. "A"
2. "B"
3. "C"
1. Position the sweeper on a level surface.
2. Raise the hopper and install the hopper safety support. Refer to
3. Loosen the locknut on the height adjustment key
1. Locknut
2. Height-adjusting key
3. Roller-height adjusting nuts
4. Loosen the roller-height adjustment locknuts
5. Pull out the height-adjustor key and move the rear roller up or down by sliding the roller-height adjusting plate to the
desired height
(Figure
6. Tighten the locknuts securing the adjustment.
7. Repeat the procedure on the opposite end of the brush. Make sure that the adjustments are the same.
Adjusting the Roller Scraper
Check and ensure the roller scraper
with a 2 mm (1/16 inch) clearance between the scraper and
(Figure
20).
(Figure
20) is adjusted
Figure 19
4. 6 to 13 mm (1/4 to 1/2 inch)
5. Brush direction
Using the Hopper Safety Support (page
(Figure
20) so it can be pulled out approximately 13 mm (1/2 inch).
Figure 20
4. Roller-height adjusting plat
5. Roller-scraper adjusting nuts
20).
the roller. Loosen the roller scraper adjusting nuts, position
roller as desired and tighten the nuts.
21
23).
Advertisement
Table of Contents
