Operation
Controls
Clutch Engagement Lever
Pull lever (Fig. 12) upward to engage clutch, push lever
downward to disengage clutch.
1
Figure 12
1. Clutch engagement lever
Operating Tips
Warning
Discharged air has considerable force and
could cause injury or loss of footing.
Stay away from discharge opening when
machine is operating.
Keep bystanders away from discharge
opening when machine is running.
Practice blowing material. It is advisable to blow the same
direction the wind is blowing to prevent material from
blowing back into the cleared area.
Lubrication
Grease Bearings & Bushings
The debris blower must be lubricated regularly. If machine
is operated under normal conditions, lubricate castor and
fan bearings and bushings with No. 2 general purpose
lithium base grease or molybdenum base grease, after every
8 hours of operation or daily, whichever comes first.
Lubricate fittings immediately after every washing,
regardless of the interval listed.
The debris blower has (6) bearings and bushings that must
be lubricated (Fig. 13). The lubrication points are: fan shaft
bearings (2), drive shaft bearings (2), over running clutch
(1) and PTO drive shaft (2).
Figure 13
14