Table of Contents
Advertisement
5
Installing the Power Wiring
Harness
Parts needed for this procedure:
1
Power wiring harness
2
Cable tie
Procedure
1. Disconnect the battery from the vehicle.
2. Attach the power wiring harness ring terminal to the
ground bolt near the vehicle fuse block.
3. Plug the harness wire into the red wire on the back of
the fuse block.
Note: If the Workman vehicle does not have an open
fuse slot, obtain and install a Toro accessory fuse block,
Part no. 92–2641.
4. Route the wiring harness alongside the main vehicle
wiring harness to the rear of the vehicle
1. Power wiring harness
5. Secure the wiring harness to the vehicle in several
places with cable ties. Keep the harness away from any
hot or rotating components.
Note: The harness is equipped with a connector for
the optional brake control kit.
6. Connect the vehicle battery.
(Figure
Figure 7
6
Mounting the Sweeper to the
Tow Vehicle
Parts needed for this procedure:
1
Hitch pin
1
Hairpin cotter
Procedure
To ensure proper debris pickup, make sure that the sweeper
frame is parallel with the ground.
1. Position the sweeper on a flat, level surface.
2. Back the tow vehicle up to the sweeper.
3. Remove the spring pin, rotate the jack down and install
the spring pin
7).
1. Jack
4. Jack up the hitch tongue until it is parallel to the ground.
5. Adjust the sweeper hitch clevis to the same level as tow
vehicle hitch as follows:
•
Remove the bolts and locknuts securing the hitch
clevis
12
(Figure
8).
Figure 8
2. Spring pin
(Figure
9) to the hitch tongue.
Advertisement
Table of Contents
